ADLY MOTO
2-8
CHECK AND ADJUST
ENGINE OIL
ϡ
ʳ
When you check the quantity of oil, the
vehicle has to stay at the ground (flat)
level.
z
Stop the engine and remove the oil level
gauge.
z
Unscrew the engine oil filler cap from the
right front corner of the engine and pull out
the dipstick.
If the oil level is stay within bottom mark of the
gauge, then the oil quantity is enough.
Refill the engine oil if it’s too less.
The standard oil type is SAE 10W/40
Re-install the oil level gauge.
Change the engine oil
Κ
z
Take-out the oil level gauge.
z
Remove the oil-release bolt underneath the
engine and release the oil.
z
Install the oil-release bolt.
z
Fill the engine oil.
ϡ
ʳ
Confirm the washer of the bolt whether
damaged.
Engine oil quantity
Κ
disassemble
Κ
2.0 Lit
change
Κ
1.6 Lit
z
Check all parts whether leaking, after
assembly.
DRIVE CHAIN
Check the drive chain condition.
z
The drive chain should be check, adjust, and
lubricate regularly.
z
Inspect the drive chain at a point on the
lower run about halfway between the
sprockets.
The free play of the drive chain should be
between 20~30mm up and down.
20~30mm
