Page 9
The user can set the temperature according to different food. It is recommended that the normal working temperature should be
180--250
℃
. It would take approximately 22~26 minutes for the oven temperature to reach 250
℃
.
When the temperature reached the pre-set temperature, the thermostat would cut-off the power supply automatically.
When the temperature is lower than the pre-set value, the thermostat would restart working.
After finishing a day’s work, rotate the controlling knob to the OFF position.
4. Installation
4.1 General information
The manufacturer cannot be held liable for any damage to property or injury to persons deriving from installation errors or from
inappropriate use of the appliance and is not responsible for any faults caused by defective installation. In such cases, the warranty shall
be null and void.
The appliance should be installed, serviced, and started up only by an authorized installer, who must comply with the safety regulations
in force in the plac8
e where the appliance is being installed.
4.1.1 Regulatory installation conditions
For your information, we remind you that all appliances installed in public assembly buildings must meet all the requirements listed below.
The appliance should be both installed and serviced in accordance with all applicable regulations and standards in force, namely:
Safety regulations on fire hazard and panic in public assembly buildings.
General regulations applicable to all appliances;
Systems burning combustible gas and liquefied hydrocarbons.
Then, follow the specific regulations according to the type of gas being used.
Heating, ventilation, refrigeration, air conditioning, and generation of steam and hot water for sanitary use;
Installation of foodservice cooking appliances;
Specific regulations applicable to each type of public assembly building (hospitals, shops, etc.).
4.2 Exhausting fumes
The appliance should be installed in a well-ventilated area, if possible under a vent hood, in compliance with all applicable regulations in
force. This will ensure that the flue gas can be completely exhausted.
4.3 Possible environmental interference
If the appliance is installed with its sides next to flammable walls (made of wood or similar materials) or to heat-sensitive walls (made of
plasterboard or similar materials), suitable protective measures should be taken to keep such walls undamaged. Therefore, apply a
coating to insulate the walls from radiative heat or keep a minimum clearance of 200 mm (8") from the side and back panels of the
appliance.
Содержание RGR24X
Страница 2: ......
Страница 6: ...Page 5 d Exploded Drawing RGR36X...