ADEMCO AlarmNet 7835C, Руководство по установке

Страница: 19 / 38

– 19 –
Exiting Program Mode, Setting Defaults & Assigning Passwords
When the last question is answered, the system validates all entries. If no errors are found, the following is
displayed:
REVIEW?
To review the programming options (to ensure that the correct responses have been made), press “Y.” The
programming questions will be displayed again, starting with Question 1. Use the UP/DOWN arrow keys
to scroll through the program fields without changing any of the values. If a value requires change, simply
type in the correct value. When the last field is displayed, the “REVIEW?” question again appears.
Setting Factory Defaults: You can reset the programming options globally to their factory default values
by pressing ESC at the “REVIEW?” prompt. A confirmation prompt will appear. Press “Y” to reset, or
press “N” to cancel this function. If you press “Y,” all programmed values will be reset to their original
factory settings.
To exit program mode and assign passwords, press “N” in response to the “REVIEW?” question. If you
are NOT programming the radio through a panel and no password has been assigned, the following
appears:
ENTER PASSWORD?
[Y/N]
Passwords can be used to split the programming questions into
two menus. See the “Password Protection” paragraph earlier in
this section. If a password is desired, press “Y”. The following
prompts appear. Press “N” if no passwords are desired.
If a password has already been assigned for the current programming menu, the “ENTER PASSWORD?”
prompt is replaced by the following:
CHG PASSWORD?
[Y/N]
Press “Y” or “N,” depending on whether you want to change the
password for the current programming menu. If [Y]es, you will
be prompted to enter the new password twice (as confirmation).
To clear an existing password, answer "Y" to the "CHG
PASSWORD" prompt, but press only the ENTER key when
prompted for the new password and its confirmation.
ENTER PASSWORD:
Enter the 4-digit password.
VERIFY PASSWORD:
Reenter the 4-digit password as confirmation.
When the password question(s) have been answered, the system exits program mode and returns to normal
mode. You can then disconnect the programming tool, or use it to trigger test messages. Refer to Testing
the System section.