ADAST V-line 899 LPG HYBRID Series, Руководство пользователя

Страница: 9 / 95

USER’S MANUAL V-line 899x.xxx/LPG HYBRID
3
Regular inspection of production quality assurance according to Annexes IV and VII of the Directive
94/9/EC executes FTZÚ, s.p., Ostrava – Radvanice, Notified body no. 1026.
Notification of quality assurance: No. FTZÚ 02 ATEX Q 020.
Considering legal metrology the dispensers have been EC – type examination (certification) according
to the annex B of the Directive 2004/22/EC – MID by an authorised body Český metrologický institut,
Okružní 31, 638 00 Brno – Notified body no. 1383.
EC - Type Examination Certificate: No. TCM 141/07 – 4505 and TCM 141/07 – 4506
The producer performed a conformity examination for the fuel dispenser with the type described in
EC – Type Examination Certificate No. TCM 141/07 – 4505 and TCM 141/07 – 4506 and technical
requirements according to the Directive of European Parliament and the Council 2004/22/EU.
The producer is competent for “The Declaration of Conformity” with the type based on production
quality assurance of measuring units according to the Directive Supplement D of European Parliament
and the Council 2004/22/EU.
Certificate of the Quality Management System for production, check-out and testing:
no. 0119-SJ-C007-07.
3.2. Operation safety
The owner is responsible for the filling station operation and is obliged to follow the course of fuel
pumping. In case a customer uses the dispenser incorrectly, the owner shall instruct him about proper use.
The owner shall also identify the hazard zone of the filling station by warning symbols (smoking
prohibited, open flame prohibited, direction of arrival to dispensers, etc.).
Operation regulations of the filling station shall be accessible for the customer, which enables him to get
information on principal obligations.
Operator’s obligation:
– Keep the operated equipment in safety and proper conditions.
– Follow the filling station operating regulations and gas equipment operating instructions.
– Without delay report any defect, failure or irregularity arisen in the course of the gas equipment
operation to the keeper and, in case of a danger in delay, put the equipment out of operation
immediately.
–
Keep the gas equipment clean and in order permanently and take care with avoiding the presence of
strangers close to the equipment.
–
Without delay report the circumstances that make him more difficult the equipment operation
(sudden indisposition, for instance)
– Record the data on the beginning and the end of the work shift and the results of revisions made by
the operators and the extent of maintenance, repairs, checks and revisions performed.
– The dispenser and storage tank operators are not supposed to make any repairs of mechanical section,
and to alter the setting of any safety fittings.
Performance of service work is a special case. Servicemen are not allowed to break operation safety
during repairs and other activities. When dispenser covers are removed, they shall be very careful to
protect both them and customers against injury.
El. current supply shall be disconnected when handling el. components. Only approved components
shall be used to replace any parts.
All parts subject to approval shall be always in conditions required by the technical documentation
(leakproofness, earthing, electrostatic belts, electrostatically conductive filling hoses, etc.).
3.3. Ecological safety
3.3.1. Petrol delivery module
In accordance with the „DIRECTIVE 2009/126/EC OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL
of 21 October 2009 on Stage II petrol vapour recovery during refuelling of motor vehicles at service
stations“
must be filling station for dispensing petrol equipped according to the national legislative
regulations of the country of destination (installation and operation of fuel dispensers) Decree recovery
system (reverse drain stage II petrol vapor - Equipment recuperate (consultation draft) petrol vapor