Adaptec ASR-2000S, Руководство по установке

Страница: 60 / 100

3-25
Installing the Driver
12
Select Edit startup.ncf.
13
Install the latest support pack for NetWare 5.
Installing the Driver in an Existing NetWare 5 Server
In this scenario, you are integrating an Adaptec RAID controller into
an existing Novell NetWare 5 server as a secondary controller. To
install the driver
1
Upgrade your NetWare server to the minimum patch level
specified by Novell.
2
Create a driver floppy disk using the Adaptec RAID Installation CD.
To create the disk
a
Insert the Adaptec RAID Installation CD in your drive and a
blank floppy disk in the floppy disk drive.
b
Copy all the files in
\packages\netware\5.x\driver
to the floppy
disk.
c
Remove the Adaptec RAID Installation CD and the driver
floppy disk.
3
Shutdown the server.
4
Install and configure the Adaptec RAID controller as a
secondary controller according to the instructions in
Chapter 2 .
Note the slot occupied by the controller, you will need this
information later in the install process.
5
Start up the server. During startup, press Ctrl+A to start
SMOR. Use SMOR to create the RAID. For details, refer to
Using SMOR on page 2-10 .
6
Start NetWare and insert the driver disk you created in Step 2 .
7
When the console prompt appears, type
load nwconfig
and
press Enter.
8
Select Driver.
9
Select Disk Driver.
10
Install
i2opci.nlm
and
bkstrosm.ham
. Specify
a:\
as the location
for the files.
Combined RAID IG.book Page 25 Thursday, May 3, 2001 11:51 PM