Adaptec ASR-2000S, Руководство по установке

Страница: 56 / 100

3-21
Installing the Driver
3
Shutdown the server.
4
Install and configure your Adaptec RAID controller as a
secondary controller according to the instructions in
Chapter 2 .
Note the slot occupied by the controller; you will need this
information later in the install process.
5
Start up the server. During restart, press Ctrl+A to start SMOR.
Use SMOR to create the RAID. For details, refer to
Using
SMOR on page 2-10 .
6
Start NetWare.
7
When the console prompt appears, type
load install
and
press Enter.
8
Select Product Options and press Enter.
9
Select Install a Product Not Listed and press Enter.
10
Insert the disk you created in Step 2 and install I
2
O and Block
Storage support only.
11
Accept the defaults for the remaining install options.
12
Return to the main install screen and select NCF Options.
13
Select Edit startup.ncf. If needed, edit the file so that
i2opci.nlm
is listed before
bkstrosm.ham
in your
startup.ncf
file.
14
Shutdown and restart the server.
Installing the Driver for a Boot Controller in a New
NetWare 4.2 Server
In this scenario, you are installing an Adaptec RAID controller as the
boot controller in a new NetWare 4.2 server. To install the driver
1
Create a driver floppy disk using the Adaptec RAID Installation CD.
To create the disk
a
Insert the Adaptec RAID Installation CD in your drive and a
blank floppy disk in the floppy disk drive.
b
Copy all the files in
\packages\netware\4.2\driver
to the floppy
disk.
Combined RAID IG.book Page 21 Thursday, May 3, 2001 11:51 PM