Adaptec ASR-2000S, Руководство по установке

Страница: 54 / 100

3-19
Installing the Driver
Installing the Driver for a Boot Controller in a New
NetWare 4.11 Server
In this scenario, you are installing an Adaptec RAID controller as a
boot controller in a new NetWare 4.11 server with other hardware.
Note: Part of this procedure requires that you have enough
free space on your
C
drive to hold the contents of the
NetWare CD.
To install the driver
1
Create a driver floppy disk using the Adaptec RAID Installation CD.
To create the disk
a
Insert the Adaptec RAID Installation CD in your drive and a
blank floppy disk in the floppy disk drive.
b
Copy all the files in
\packages\netware\4.11\driver
to the
floppy disk.
c
Remove the Adaptec RAID Installation CD and the driver
floppy disk.
2
Install and configure your Adaptec RAID controller and hard
drives according to the instructions in
Chapter 2 . Verify that
the Adaptec RAID controller is the primary controller. If other
controllers are present, install the Adaptec RAID boot
controller in a lower-numbered PCI slot than the other
controllers.
3
Install and configure a secondary controller, if any.
4
Start up the server. During restart, press Ctrl+A to start SMOR.
Use SMOR to create the RAID. For details, refer to
Using
SMOR on page 2-10 .
5
Create a 750-MB DOS partition on the Logical Storage Unit
(LSU), which can be a drive or array group, with the lowest
LSU ID.
6
Boot the server to DOS from the partition you created in Step 5 .
Verify that you load the required CD drivers.
7
Insert the NetWare 4.11 CD.
Combined RAID IG.book Page 19 Thursday, May 3, 2001 11:51 PM