Adaptec ASR-2000S, Руководство по установке

Страница: 40 / 100

3-5
Installing the Driver
d
When you see the Adaptec splash screen, click Create
Driver Disk
. Then, click the appropriate operating system.
e
Insert a floppy disk and click OK. The system creates the
driver disk.
2
Shut down the system and remove the Adaptec RAID
Installation CD.
3
Restart the system.
4
Click the Windows Start button, select Run, and type
a:\w2kprep.exe .
5
Remove the driver disk.
6
Insert the Windows 2000 CD and run the
setup.exe
program.
Setup copies some files and then reboots the system.
7
When the system is restarting, a blue screen appears after the
hardware detection message. When prompted to install a
third-party driver, press F6
.
Note:
You only have 5 seconds to press the F6 key during the
installation startup. A hardware detection message appears
when F6 is active. Press F6 at this time; otherwise, you must
restart the installation process to complete this procedure
correctly.
8
When prompted, insert the driver disk you created in Step 1
and select Adaptec I
2
O RAID Host Adapter Driver for
Windows 2000 . Press Enter and follow the instructions
displayed.
Windows NT 4.0
The following driver installation scenarios exist for
Windows NT 4.0:
■
Installing the Driver in a New System with Only One Controller on
page 3-6
■
Installing the Driver in a New System with Other Hardware on
page 3-7
Combined RAID IG.book Page 5 Thursday, May 3, 2001 11:51 PM