2-10
Adaptec RAID Installation Guide
Using SMOR
You need to run SMOR in systems where you need to configure the
controller and set up disk arrays before the operating system has
been installed. Run SMOR as directed in the installation procedures
in this Installation Guide to:
■
Check the cache memory module after installing the controller
(refer to
Step 2 on page 2-7
).
■
Configure the controller as a boot controller after installing the
controller (refer to
Determining the Booting Controller on
page 2-9
).
■
Create disk arrays during driver installation (see
Chapter 3
).
After your system is set up, you can use all of the advanced features
of Storage Manager Pro or Storage Manager to modify and improve
the RAID. Complete SMOR documentation is provided in the
Adaptec Storage Management Software User’s Guide.
To run SMOR and configure a new system
1
Press Ctrl+A when the Adaptec I
2
O BIOS message appears
during boot to start SMOR.
Note:
The Adaptec RAID Installation CD boot utility can create
a bootable floppy disk that will run SMOR. This disk
automatically starts SMOR, enabling you to perform
configuration tasks when you can’t start SMOR from the
SCSI RAID controller using Ctrl+A.
2
Inspect the hardware configuration.
a
Verify that all peripheral devices and controllers are shown.
If any devices are missing from the display, exit SMOR and
check your hardware connections.
b
View the Information window for each controller to verify
that all installed expansion and memory modules are
shown. Write down the IRQ and address displayed in the
Configuration tab—you may need this information later.
Combined RAID IG.book Page 10 Thursday, May 3, 2001 11:51 PM
Содержание ASR-2000S
Страница 1: ...R AdaptecRAID Installation Guide ...
Страница 35: ......
