ASD SERIES INSTALLATION AND OPERATION MANUAL
10
FIGURE 6
ASD-29, 29 (1P), 45, 48 DRIVE LAYOUT (SEE LEGEND BELOW FOR NUMBERED ITEMS)
LEGEND:
1. Adjustable Trimpots on Drive and Signal Isolator:
Maximum Speed (MAX), Minimum Speed (MIN), Acceleration (ACCEL), Deceleration
(DECEL), DC Injection Brake (DECEL), Boost (BOOST), Current Limit (CL), Jog (JOG), Slip Compensation (COMP)
– see Section 12 on
page 17. Signal Offset (OFFSET) and Signal Scaling (SCALE)
– see Section 14.2 on page 20.
2. Jumper J2:
Motor Horsepower selection. See Section 10.2 on page 15.
3. Jumper J3:
Automatic Ride-Through or Manual Start selection. See Section 10.3 on page 15.
4. Jumper J6:
Adjustable Boost selection. See Section 10.5 on page 16.
5. Jumper J4:
Frequency Multiplier selection. See Section 10.4 on page 15.
6. Jumper J7:
Regeneration or DC Injection Braking. See Section 10.6 on page 16.
7. Jumper J5:
Motor Frequency selection. See Section 10.4 on page 19.
8. Jumper J8:
"Run" or "Fault" Output Relay Operation selection. See Section 10.7 on page 16.
9. Jumper J9:
Normally Open or Closed Stop Contact selection. See Section 10.8 on page 16.
10. Jumper J10:
Constant or Variable Torque selection. See Section 10.9 on page 16.
11. Jumper J11:
Factory use only.
12. Jumper J12:
Switching Frequency and GFCI selection. See Section 10.11 on page 16.
13. Terminal Block TB1:
AC Line input and motor connections. See Sections 7.1 and 7.2 on page 13 and 14.
14. Signal Isolator:
See Section 14 on page 18.
