Chapter 1 - System Board 1-9
3.
Follow the ESD precautions in section 1.5.1 before handling a system
component.
4.
Remove any expansion boards or peripherals that block access to components
you are installing.
5.
See the following sections for specific instructions on the component you wish
to install.
Do not attempt the procedures described in
the following sections unless you are a
qualified service technician.
1.5.3
Post-installation Instructions
Observe the following procedures after installing a system component:
1.
Check that the components are installed according to the instructions in their
respective sections.
2.
Make sure you have set all the required jumpers. See section 1.3.2 for the
correct jumper settings.
3.
Replace any expansion boards or peripherals that you removed earlier.
4.
Replace the system cover.
5.
Connect the necessary cables and turn on the system.
