![background image](http://html.mh-extra.com/html/acer/altos-330-series/altos-330-series_user-manual_5812094.webp)
Chapter 3 - System Utilities 3-15
Send Start Unit Command
This option, which is supported by some SCSI devices, determines whether the
Start Unit Command (SCSI command 1B) is sent to the SCSI device (most devices
do not require this). Enabling this option reduces the load on your computer's
power supply by allowing the SCSI controller to power-up SCSI devices one-at-a-
time when you boot your computer. Otherwise, the devices all power-up at the
same time. Most devices require you to set a jumper before they can respond to
this command.
When set to Yes, the Start Unit Command is sent to the SCSI device during
bootup. When set to No, each SCSI device powers-up in its normal fashion. The
default setting is No.
The Send Start Unit Command setting is valid
only if the host adapter BIOS is enabled.
If this option is enabled for more than one SCSI device, the Start Unit Command
is sent first to the device with the lowest SCSI ID. When this device responds to
the SCSI controller, the Start Unit Command is sent to the next highest SCSI ID
with a setting of Yes. The process continues until all supported devices respond
to the SCSI controller.
If many drives are set to
Yes
for Send Start Unit
Command, the boot time varies depending on
how long it takes each drive to spin up.