Accurate Technology Model 9, Руководство по установке

Страница: 26 / 132

INSTALLATION & SETUP
Step 9 >
Press UP to increase contrast to a normal viewing level.
Step
10 >
Pivot the projector and move it side to side as necessary to display a
symmetrical crosshatch centered left-to-right on the screen. The pivot point should be at
the tear wing nut of the green lens to avoid changing the throw distance.
Step 11 >
Tilt the projector until the center horizontal line is level and centered with
the screen. Adjust the feet of the projector or ceiling mount as required.
Step 12 >
A red image is displayed. Loosen the rear wing nut on the red lens. Rotate
the lens using the wing nut until the picture is focused in the center. Tighten the rear wing
nut.
Step 13 >
Loosen the front wing nut on the red lens. Rotate the front lens barrel until
the picture is focused in the corners. Tighten the front wing nut.
Step 14 >
A blue image is displayed. Loosen the rear wing nut on the blue lens. Rotate
the lens using the wing nut until the picture is focused in the center. Tighten the rear wing
nut.
Step 15 >
Loosen the front wing nut on the blue lens. Rotate the front lens barrel until
the picture is focused in the comers. Tighten the front wing nut.
Step 16 >
Press UP or DOWN to adjust for best electrical focus at the center of the
picture.
Step 17 >
On the Model 8 & 9, loosen the three bolts labeled ''B'' One is located on the
top plate. The other two are below the red lens.
On the Model, loosen the four bolts labeled "A" Loosen the two bolts labeled ''B''.
Step 18 >
A red and green crosshatch is displayed. Move the red lens so that the left
and right edges of the red crosshatch match the green.
2-20