Accurate Technology Model 9, Руководство по установке

Страница: 28 / 132

INSTALLATION & SETUP
On the Model 8, adjust the large allen head bolt located at the upper right comer of the
green lens mounting plate. Turn the Before After bolt head until the top and bottom areas
of the picture are equally refocused.
NOTE: On all models, it may be necessary to readjust the lens ' rear wing nut to keep the
center defocused.
Step 25 >
Rotate the green lens using the rear wing nut until the picture is focused in
the center. Tighten the rear wing nut. If necessary, loosen the front wing nut, rotate the
front lens barrel to readjust the focus in the corners, then re-tighten the wing nut.
Step 26 >
A red image is displayed. Loosen the rear wing nut on the red lens and
slightly defocus the center of the picture.
Step 27 >
On the ''LC'' models, locate the two adjustment bolts at the upper right corner
of the red lens mounting plate (viewed from the front).
Adjust the two bolts until the top and bottom areas of the picture are equally defocused.
Use the same technique as that used for the green adjustment (step 24).
On the Model 8, adjust the large allen head bolt located at the upper right comer of the
red lens mounting plate. Turn the bolt head until the top and bottom areas of the picture
are equally refocused.
Note: On all models, it may be necessary to readjust the lens' rear wing nut to keep the
center defocused.
Step 28 >
On the Model 9, locate the two adjustment bolts at the upper left corner of
the red mounting plate (viewed from the front).
Adjust the two bolts until the left and right areas of the picture are equally defocused. Use
the same technique as that used for the previous adjustment (step 27).
On the Model 8, adjust the large alien head bolt located at the lower left comer of the red
lens mounting plate. Turn the bolt head until the left and right sides of
2-22