Accurate Technology Model 9, Руководство по установке

Страница: 90 / 132

OPERATION
The Start Field
The Start field shows the start time of the event. With the cursor positioned on the Start
field use the number keys to enter the start time. Use the notation previously defined by
the Set Clock utility (12 hour or 24 hour). If using a 12 hour clock, press
ENTER to
toggle between a.m. and p.m..
Notes: Only valid entries are accepted. For example, if "4'' is entered as the first digit of
the Start time it will not be accepted. The first digit must be either ''0'' or ''1 '' when using
a 12 hour clock, and ''0'', ''1 '' or ''2 '' when using a 24 hour clock.
The Enabled Field
The Enabled field allows you to enable or disable a programmable event. When enabled,
the event is performed as programmed. When disabled, the programmed event is ignored.
A check mark indicates that the event is enabled. With the cursor positioned on the
Enabled field press
ENTER to toggle display of the check mark.
General Notes about Programmable Events
1) All events are ignored if Programmable Events is set to Off in the Preferences menu
(
UTIL 5 ).
2) The projector must be turned on for programmable events to take place.
3) Be careful not to schedule two events so close to each other such that the second event
is scheduled to begin before the first event is complete; otherwise the second event may
be ignored. For example, do not schedule an event to take place one minute after a full
ACON auto-convergence. A full ACON convergence takes longer than one minute to
complete.
4) If the projector is not at presentation level when an event is scheduled to begin, that
event will be ignored unless presentation level is returned within the minute that that
event is to take place.
5) An error or ''invalid'' message is temporarily displayed at the bottom of the feature box
when an entry is invalid or does not make sense.
6) ''Error'' in an Enabled field indicates an invalid entry for that event.
7) Events scheduled at the same time are performed in the order listed in the
Programmable Events feature box. Events never occur simultaneously.
About Channel Up/Down Events ...
Channel Up/Down events are handled differently than other events. A Channel Up or
Channel Down event is continuously repeated at the time interval set by the Interval field.
The process begins at the start time set by the Start field. This feature is provided for
applications such as surveillance or status display systems where multiple sources are
sharing one projection display. For example, a bus terminal may use this feature to
display a number of different bus schedules, each displayed for ten seconds at a time.
3-46