Accurate Technology Model 9, Руководство по установке

Страница: 32 / 132

INSTALLATION & SETUP
Step 10 >
Adjust C linearity as follows:
Press UP or DOWN until the horizontal line through the center of the crosshatch is
equally distant from the lines at the very top and bottom.
Press LEFT or RIGHT until the center of the crosshatch is equally distant from the
vertical lines at the left and right edges.
Step 11 >
Adjust S linearity as follows:
Press UP or DOWN until the height of each crosshatch square is equal from the top to
the bottom.
Press LEFT or RIGHT until the width of each crosshatch square is equal from the left to
the right.
The source connected to the currently selected input should now be visible. If there is no
picture, check to see if the source is active.
Step 12 >
Press UP , DOWN , LEFT or RIGHT to adjust phase until the picture is
centered on the screen.
Step 13 >
Press UP , DOWN , LEFT or RIGHT to adjust the size of the picture.
Ensure that objects in your picture have the correct shape. For example, if there is a circle
in your picture, size should be adjusted until the circle is round, not oval.
Step 14 >
The final step is convergence. lf the projector includes the ACON option,
press EXIT CONV then 4 to exit the guide and allow ACON to converge the system.
Otherwise, press EXIT CONV then 1 to enter Guided Convergence.
Reminder: Remember that all of the adjustments above should be repeated for other
sources in the system.
2.10 Memory Setup
This section explains how to set up projector memories to improve the performance of
the projector's ASI
and ASR features. If you are not familiar with setup memories, read
section 3, Operation, prior to memory setup; in particular, read section 3.4, Setup
Memories, and the ASI with Save and Turn ASR On/Off entries in section 3.7, Utility
Features. If the projector's setup memories are properly set up, the projector will be
easier to use and operate.
2-26