100
Acuvim-L
2. Press “V/A” key to go to the device address page. It
shows the Modbus address of the device.
3. Press “V/A” key to go to the baud rate setting page.
Then press “H” key and “P” key simultaneously to go
to the Ethernet module setting page.
4. Set configuration mode in the first setting page.
“1” means that users configure module settings with
DHCP protocol while “0” means that users configure
module settings with manual setting. Press “P” key
or “E” key to select configuration mode, press “V/A”
key to accept and go to the second setting page for
IP Address.
Note:
If you select the “1” mode, please go to step 12
directly and reset module. Wait until the reset is finished and find the new IP address
in the following step.
Fig. 4-5
Fig. 4-6
Fig. 4-7
Shop for Power Metering products online at:
1.877.766.5412
www.
PowerMeterStore
.com
