ACCU-SYSTEMS DD, Руководство пользователя

Страница: 9 / 27

E. Inserting Dowels
1. Place the gun to the dowel hole and push the trigger button. You will first see a shot of glue
(or water) and then a dowel will follow it into the hole. Keep the nozzle firm against the material
and in line with the hole, it may take a little practice, but before long you will find it quite easy to
do. Do not push hard enough to retract the fingers back into the gun body. Also keep the hoses as
straight as possible from the machine to the gun. This will help the machine to run smoothly.
If a dowel exits the nozzle, but for some reason did not go into a dowel hole, NEVER PUSH THE
DOWEL INTO THE NOZZLE TO RESHOOT IT!! Always pull the dowel out and push the
trigger for a new dowel.
(If you push the dowel back into the nozzle, it will fall on top of the slide block, and will
damage the machine. You will have to take the front handle off to get it out before another
dowel can be shot out of the nozzle.)
2. If you are shooting glue, you must FLUSH THE GLUE FROM THE GUN AS SOON AS POS-
SIBLE. Be sure to flush the system within 20 minutes to insure no glue drying in the tip. To
flush the system, point the gun into the purge bucket and flip the “H20-Run-Glue” switch to H20
until you see a clear stream of water coming out of the gun for a few seconds. Flip the switch
back to the RUN position. Inspect the nozzle and front of gun, removing any build up of glue with
a rag. Return the gun to it’s holster.
3. You may now turn the main power switch off, this will also shut off the bowl feeder. Shut off
the air or disconnect the air line. Your machine is now ready for the next time you use it.