ACCU-SYSTEMS DD, Руководство пользователя

Страница: 7 / 27

7. Flip the H20-RUN-GLUE switch to the H20 (water) side and you should start to see water
exit the tip of the gun in about 10-15 seconds. Then flip the switch to the glue side and you
should start to see glue exit the tip of the gun in about 10-15 seconds.
8. Once the glue arrives flip the switch in the middle”RUN” position. You are now ready to
shoot.
9. You may need to make a few adjustments as you go along, like increase or decrease the
glue pressure or adjust the glue timer inside the control panel for more or less glue. You will
have to shoot a few dowels to see if this is necessary.
10. After each time you use the machine you will need to flush the glue back out of the line,
to do this hold the gun over the purge bucket, flip the switch to the H20 side and you should
start to see water come out of the gun in 7-10 seconds. Let it run a bit before you flip the
switch back to run.
11. After this you must clean off the nozzle, and any glue to keep it from drying and causing problems.