ACCU-SYSTEMS DD, Руководство пользователя

Страница: 16 / 27

F- IS THE DOWEL HOSE FULL OF DOWELS?
Only one dowel at a time should be in the hose. If you do not get a dowel out the front of the gun
only cycle it once more then stop if you still haven’t gotten a dowel. Open the dowel reject slide
just underneath the nozzle of the gun and empty out any build up of dowels you have. If a dowel is
jammed, turn off the dowel feeder so as not to continue to insert dowels into the hose. After the
line is clear you can turn the feeder back up cycle the machine and make sure a dowel comes out
the reject slide, then close the slide and cycle it two more times to get a dowel out the nozzle.
G- IS THERE A DOWEL ON TOP OF SLIDE BLOCK?
You should never push a dowel back into the nozzle to try and shoot it. It will only fall on top of
the slide block and cause the gun to not work. You may also bend or damage the slide block and
cylinder if repeatedly hitting the block. After you have checked all the above, remove the four allen
head screws from the front handle and remove the slide block and cylinder to inspect for a dowel on
top. If there is a dowel, remove it and inspect the block to see if it is bent. If it is bent you will
need a new cylinder, if not, re-assemble and test again.
2. If dowels come back into the singulator after being pushed into the supply hose...
A- CHECK SOLUTIONS FROM QUESTION #1.
B- CHECK FOR A KINK IN THE DOWEL SUPPLY HOSE.
It is possible to have a kink in the dowel supply hose somewhere under the hose covering... Undo
the dowel supply hose at the gun and cycle machine to see if a dowel exits the hose. DANGER !!!
DO NOT POINT THE DOWEL HOSE AT ANY PART OF THE BODY. THE DOWEL
WILL EXIT AT A VERY HIGH SPEED AND COULD CAUSE INJURY. If dowels do not
come out a new hose will be needed.
C- THERE MAY NOT BE ENOUGH AIR PRESSURE AT THE MACHINE.
Make sure that proper air is available and set the regulator as stated earlier.
D- CHECK TO SEE IF YOU ARE USING THE WRONG SIZE OF DOWEL.
If your dowel is too long it may be causing the problem.
3. If there is excessive glue on nozzle and plunger... ?
A- IS THE GLUE PRESSURE TOO HIGH?
There is sometimes a fine line between to much and not enough glue in the hole. But if you are get-
ting an excessive amount of glue on the nozzle you are putting to much glue in the hole causing the
excess to be pushed back out and into the nozzle of the gun. Lower glue pressure to as low as possi-
ble.