Accton Technology ES4626, Руководство по управлению

Страница: 319 / 523

319
no mls qos aggregate-policer <aggregate-policer-name>
Function:
Define a policy set that can be used in one policy map by several classes; the
“
no mls qos aggregate-policer <aggregate-policer-name>
” command
deletes the specified policy set.
Parameter: <aggregate-policer-name>
is the name of the policy set;
<rate-kbps>
is the
average baud rate (in kb/s) of classified traffic, range from 1,000 to
10,000,000;
<burst-kbyte>
is the burst value (in kb/s) for classified traffic,
range from 1 to 1,000,000;
exceed-action drop
means drop packets when
specified speed is exceeded;
exceed-action policed-dscp-transmit
specifies to mark down packet DSCP value according to
policed-dscp
mapping when specified speed is exceeded.
Default:
No policy set is configured by default.
Command mode:
Global Mode
Usage Guide:
If a policy set is using by a policy map, it cannot be deleted unless the
reference to the policy set is cleared in the appropriate policy map with “
no
police aggregate <aggregate-policer-name>
” command. The delete
should be performed in Global Mode with “
no mls qos aggregate-policer
<aggregate-policer-name>
” command.
Example:
Set a policy set named “agg1”, the policy set defines the bandwidth for packets
to 20 MB/s, with a burst value of 2 MB, all packets exceeding this bandwidth
setting will be dropped.
Switch(Config)#mls qos aggregate-policer agg1 20000 2000 exceed-action drop
13.1.2.2.9 police aggregate
Command: police aggregate <aggregate-policer-name>
no police aggregate <aggregate-policer-name>
Function:
Apply a policy set to classified traffic; the “
no police aggregate
<aggregate-policer-name>
” command deletes the specified policy set.
Parameter: <aggregate-policer-name> is the policy set name.
Default:
No policy set is configured by default.
Command mode:
Policy class map configuration Mode
Usage Guide:
The same policy set can be referred to by different policy class maps.
Example:
Apply policy set “agg1” to packets satisfying c1 class rule.
Switch(Config)#policy-map p1
Switch(Config-PolicyMap)#class c1
Switch(Config--Policy-Class)#police aggregate agg1
Switch(Config--Policy-Class)#exit