
73
72
a
After inflating the airbags there is a definite
background noise
1. This noise is due to the release valve
equalizing the pressure.
2. After a few minutes the pressure drop should
not be clearly visible any more.
3. If the pressure drop is still clearly visible,
the system needs to be repaired. Send the ABS-
System in for service.
14.2 WARRANTY
a
To extend your warranty of the ABS
®
-System
from 2 years to 4 years please complete the
warranty card online no later than 30 days after
your purchase under:
14.3 TECHNICAL DATA
a
Volume of airbag:
2 x 85 litre airbags
a
Weight of system: 1200g
a
Airbagmaterial: Polyamid 6.6
a
Release::
Pyrotechnical ignition in the activation handle
a
Filling procedure:
Within approx. 1 second, 90 litres (23,8 US
gallon) of a gas-air mix is forced into the
two airbags while the remaining approx. 80
litres (21,1 US gallon) will take 1.5 seconds
(depending on outside temperature and
elevation).
a
Cartridges:
Are made from highly durable materials with an
allowable pressure of more than 300 bar (4400
psi). Depending on the model, the cartridges
comply with the guidelines of the EG or DOC /
TC for North America.
a
Carrying system:
Complies with the TÜV requirements for
extreme operational demands. The tensile
strength for all weight bearing straps equals
3000 N (674lbf).
a
Operating temperature:
von -40°C bis +50°C
Subject to technical modifications.
14.4 PERMITS AND CONFORMANCE
a
The lower limit of 20 activations as prescribed
by the EN standard is guaranteed. The service
life and functioning of the equipment depends
on the level of use. If the described maintenance
intervals are observed, we recommend
replacement after a service life of 10 years.
a
The nature of the materials and the kind of
workmanship used for the development of
the ABS Avalanche Airbag System are based
on the standard values of comparable usage
requirements. These standard values form
the requirement profile for the material and
operating tests conducted by TÜV Süd Product
Service GmbH within the Federal Consumer
Product Safety Act, according to PPE directive
2016/425 EWG as well as the CE guidelines.
Yet during an avalanche incident there could
be forces and circumstances, which will exceed
these standard values. We would therefore
explicitly point out that the ABS
®
Avalanche
Airbag System in its entirety and in parts (airbag
material, attachments, backpack, etc.) cannot
withstand all possible demands which will arise
during an avalanche incident.
Manufacturer:
ABS Protection GmbH
Gundelindenstr. 2
80805 München
Country of origin:
Germany
Type:
ABS
®
Avalanche Airbag
System
TÜV Süd Product Service GmbH
Daimlerstr. 11, 85748 Garching
Test centre No. 0123.
ABS Protection GmbH is a certified company
according to ISO 9001: 2015 standards.
The ABS-System is “Made in Germany”.
13.4 Zulassung / Konformität
Hersteller: ABS Peter Aschauer GmbH
Herstellerland: Deutschland
Typ: ABS-Lawinenairbag-System
Für die Beschaffenheit der für das ABS-Lawinenairbag-System
verwendeten Materialien und für die Art der Verarbeitung wurden
Richtwerte aus vergleichbaren Anforderungsbereichen zugrunde
gelegt . Diese Werte bilden das Anforderungsprofil der von der
TÜV Süd Product Service GmbH vorgenommenen Material- und
Funktionsprüfung im Rahmen der GS-Zeichen-Prüfung (Geprüfte
Sicherheit), nach den PSA Richtlinien 89/686 EWG und den
CE-Richtlinien . Trotzdem können gerade in Lawinen Kräfte und
Umstände auftreten, die diese Werte übersteigen . Wir weisen
deshalb ausdrücklich darauf hin, dass das ABS-Lawinenairbag-
System in seiner Gesamtheit und in Einzelbereichen (Airbag-
material, Befestigungsmaterial, Rucksack etc .) nicht allen
möglichen, in Verbindung mit Lawinen auftretenden Belastungen
standhalten kann .
TÜV Süd Product Service GmbH, Daimlerstr . 11,
85748 Garching . Prüfstellennummer 0123 .
Die ABS Peter Aschauer GmbH ist ein nach
ISO 9001:2000 zertifizierter Betrieb .
Das ABS-System ist Made in Germany
13.5 Servicecenter
Die für den ABS Kundendienst zuständigen Firmen in den
jeweiligen Ländern finden Sie auf unserer Internetseite
unter
www.abs-airbag.com/de/kontakt.html
.
Deutsch
18
140325_ABS_GBA_2014_Innenteil_RZ.indd 18
25.03.14 12:59
ENGLISH