ABB Welcome IP, Системное руководство

Страница: 35 / 82

Commissioning
System Manual 2CKA000073B9795 │35
4.2.3 Outdoor station without display
For commissioning you are located in: Section 1 (Preparing the devices)
Overview of commissioning: see chapter 4.1 “Overview of commissioning“
on page 30
The LEDs light up permanently during the automatic boot up.
1
2
Fig. 17: Outdoor station without display: Engineering mode
To address the device, perform the following steps:
1. Activate "Engineering mode":
– After the LED icons [1] in the camera have stopped being lit up, keep the top doorbell
button pressed for 11 seconds. In case of several bell spaces, the first doorbell button
below the audio shell [2].
– The LEDs flash green.
2. Switch to the indoor station.
Fig. 18: Outdoor station without display: Addressing via indoor station