- 76 -
000725AG
7 - Operation
C
ommissioning (Via internal Webserver)
Do not place objects of any kind on the inverter during operation! Do not touch the heat sink
while the inverter is operating! Some parts may be very hot and could cause burns.
Before proceeding with commissioning, make sure you have carried out all the checks and
verifications indicated in the section on preliminary checks.
Commissioning could be carried out via wireless connection to the inver
-
ter’s internal webserver. Initial setup of the system must therefore be car
-
ried out via a tablet, notebook or smartphone with a wireless connection.
• Close the DC disconnect switch to supply the inverter with input voltage
from the photovoltaic generator.
Make sure irradiation is stable and adequate for the inverter commissioning procedure to be
completed.
• Once powered, the inverter will automatically create a wireless network
(approx. 60 seconds after its switch-on) that will be visible as an Access
Point from the user devices previously mentioned (tablet, smartphone,
etc.).
• Enable the wireless connection on the device which is being used for
the board setup (tablet, smartphone or PC) and connect it to the Access
Point created by the inverter system: the name of the wireless network
created by the system that the connection should be established with,
will be:
ABB-XX-XX-XX-XX-XX-XX
where “
X
” is a hex digit of the wireless MAC address (MAC address can
be found on the “Wireless Identification Label” placed on the side of the
inverter or applied during the commissioning phase to the quick installa-
tion guide on cover page).
The screens shown below pertain to a tablet with the Android operating system. Screens on
other devices or operating systems may differ.
ABB-XX-XX-XX-XX-XX-XX
• When required digit the network password
ABBSOLAR
After 24 hours wich the inverter is power-on, the access point default password “ABBSOLAR”
will be disabled and any subsequent access to the internal webserver will be possible only
using the
PRODUCT KEY
(printed on the “Wireless identification label” and applied during the
commissioning phase to the quick installation guide on cover page) as access point password.