5. Install the nuts and washers on the connector block bolts.
6. Tighten the nuts to the correct torque. For the specification, refer to section
7.5
Connect the AC auxiliary power cable in the power cabinet
Preliminary requirements
•
Torque screwdriver, cross
•
Wire cutter
•
Wire stripper pliers
•
Crimp pliers
•
•
AC auxiliary power cable.
•
Ferrules
Note: The AC auxiliary power cable provides the control power to the
charge post.
Procedure
1. Strip the insulation from the ends of
the wires (A) to (D).
•
For the procedure, refer to section
.
•
For the specification, refer to
2. Crimp ferrules onto the end of the
wires. Refer to section
3. Loosen the screws of the terminal
block X-10.
4. Connect these wires:
•
PE wire (A), green/yellow, to the
terminal X10-1 (E)
•
L1 wire (B), brown, to the terminal X10-2 (F)
•
L2 wire (C), black, to the terminal X10-3 (G)
•
L3 wire (D), grey, to the terminal X10-4 (H)
5. Tighten the screws to the correct torque. For the specification, refer to section
C
A
D
B
H
G
F
E
Electrical installation of the power cabinet
46
9AKK107992A2254-EN | 005