7.8
Connect the control cable for the tilt sensors to the power
cabinet (option)
Preliminary requirements
•
Torque screwdriver, cross
•
Wire cutter
•
Wire stripper pliers
•
Crimp pliers
•
Control cable for the tilt
sensors. Refer to section
•
Ferrules
Procedure
1. Strip the insulation from the ends
of the wires (A) to (H). For the
specification, refer to section
.
2. Crimp ferrules onto the end of the
wires.
3. Loosen the screws of the terminal
block X-1.
4. Connect these wires:
•
V+ wire (A) from the external
customer interface, wire number 1,
to the terminal X1-1 (I)
•
V- wire (C) from the external
customer interface, wire number 2,
to the terminal X1-3 (K)
•
Rin wire (E) from the external customer interface, wire number 3, to the
terminal X1-5 (M)
•
Rout wire (G) from the external customer interface, wire number 4, to the
terminal X1-7 (O)
5. Tighten the screws to the correct torque. For the specification, refer to section
F
G
H
E
B
C
D
A
I
J K L M N
P
O
Electrical installation of the power cabinet
9AKK107992A2254-EN | 005
49
