ABB S4Cplus, Инструкция

Страница: 71 / 86

&DOLEUDWLRQ
3.2.10. Checking the calibration position
69 3HAC 16578-1 Revision: E
© Copyri
ght
200
3-2007 ABB.
All rights reserved.
&KHFNLQJWKHFDOLEUDWLRQSRVLWLRQ
*HQHUDO
Check the calibration position before beginning any programming of the robot system. This
may be done in one of two ways:
•
Using a MoveAbsJ instruction with argument zero on all axes.
• Using the Jogging window on the teach pendant.
8VLQJD0RYH$EV-LQVWUXFWLRQRQWKH7386&SOXV
This section describes how to create a program, which runs all the robot axes to their zero
position
8VLQJD0RYH$EV-LQVWUXFWLRQRQWKH)OH[3HQGDQW,5&
This section describes how to create a program, which runs all the robot axes to their zero
position.
$FWLRQ 1RWH
1. Create a new program.
2. Use MoveAbsJ.
3. Create the following program:
MoveAbsJ
[[0,0,0,0,0,0],[9E9,9E9,9E9,9E9,9E9,
9E9]]\NoEOffs, v1000, z50, Tool0
4. Run the program in manual mode.
5. Check that the calibration marks for the axes align
correctly. If they do not, update the revolution
counters!
The calibration marks are shown in
section
&DOLEUDWLRQVFDOHVDQG
FRUUHFWD[LVSRVLWLRQRQSDJH
.
How to update the revolution
counters is detailed in section
8SGDWLQJUHYROXWLRQFRXQWHUVRQ
SDJH
6. Check that the positions of axes 1-2-3 are reached
and that the calibration marks on axes 4-5-6 are
aligned correctly.
If they are not, update the revolution counters!
Detailed in section
8SGDWLQJ
UHYROXWLRQFRXQWHUVRQSDJH
.
$FWLRQ 1RWH
1. On ABB menu tap Program Editor.
2. Create a new program.
3. Use MoveAbsJ in the Motion&Proc menu.
4. Create the following program:
MoveAbsJ
[[0,0,0,0,0,0],[9E9,9E9,9E9,9E9,9E9,
9E9]]\NoEOffs, v1000, z50, Tool0
5. Run the program in manual mode.
&RQWLQXHVRQQH[WSDJH