Description of application and parameters
Application "CO2 sensor"
Product manual 2CKA001473B9679
│159
11.5.16 Settings— Switch command below threshold 1
Options:
Off
On
The parameter defines which state should be sent after threshold value 1 is undershot.
Notice
The parameter is available only when parameter "Control value output format" is
set on "Switching command".
11.5.17 Settings— Priority below threshold 1
Options:
End priority
OFF with priority
ON with priority
The parameter defines which state should be sent after threshold value 1 is undershot.
Notice
The parameter is available only when parameter "Control value output format" is
set on "Priority".
11.5.18 Settings — Value below threshold 1 (-100) for output format percent
Options:
0-100
If the parameterised value of the threshold is undershot, a defined parameterised value is sent
on the KNX bus to reset the event that occurred beforehand. E.g., a fan is activated when the
threshold is undershot to supply the room with fresh air. When the change of air has occurred
and the CO2 concentration has again dropped below the threshold value, the fan is switched
off.
Notice
The parameter is available only when parameter "Control value output format" is
set on "Percent".
Содержание ClimaECO SBS/Ux.0.1 Series
Страница 382: ...Notes Product manual 2CKA001473B9679 382 13 Notes ...
