ABB ACS310, Руководство пользователя

Страница: 63 / 376

Start-up and control with I/O 63
Select the application macro according to which the
control cables are connected.
Continue with the application set-up. After
completing a set-up task, the Start-up assistant
suggests the next one.
• Press
(when is highlighted) to
continue with the suggested task.
• Press key to highlight and then press
to move to the following task without doing the
suggested task.
• Press to stop the Start-up assistant.
DIRECTION OF THE MOTOR ROTATION
Check the direction of the motor rotation.
• If the drive is in remote control (REM shown on the
status line), switch to local control by pressing .
• If you are not in the Output mode, press
repeatedly until you get there.
• Increase the frequency reference from zero to a
small value with key .
• Press to start the motor.
• Check that the actual direction of the motor is the
same as indicated on the display ( means
forward and reverse).
• Press to stop the motor.
To change the direction of the motor rotation:
• If parameter
9914 PHASE INVERSION is not
visible, first set parameter 1611 PARAMETER
VIEW to 3 ( LONG VIEW ).
• Invert the phases by changing the value of
parameter 9914 to the opposite, ie from 0 ( NO ) to
1 ( YES ), or vice versa.
• Verify your work by applying input power and
repeating the check as described above.
• Set parameter 1611 back to 2 ( SHORT VIEW ).
9902 APPLIC MACRO
EXIT SAVE
00:00
PAR EDIT
[1]
ABB STANDARD
REM
OK
Continue
Skip
OK
EXIT
Do you want to
continue with
EXT1 reference setup?
Continue
Skip
EXIT OK 00:00
REM CHOICE
LOC
REM
EXIT
DIR
MENU 00:00
LOC xx.xHz
xx x Hz .
x x A .
xx x % .
forward
direction
reverse
direction
1611 PARAMETER VIEW
CANCEL SAVE 00:00
PAR EDIT
[3]
LONG VIEW
LOC
9914 PHASE INVERSION
CANCEL SAVE 00:00
PAR EDIT
[1]
YES
LOC
Aotewell Ltd www.aotewell.com Industry Automation
HongKong|UK|China sales@aotewell.com +86-755-8660-6182