ABB ACS260-04 Series, Руководство пользователя

Страница: 36 / 98

36 Start-up
To allow the ACS260 to be controlled from the keypad in a forward and reverse
direction, set parameter 1103 PRIMARY COMMAND SOURCE MODE =2:
13. Operation is the same as when parameter 1103 PRIMARY COMMAND SOURCE
MODE =1 for start, stop and changing speed.
14. Press the key. The display changes to ( H 0.0 ) .
15. Press to increase speed
16. The drive will run forward, increasing speed until is released. Acceleration is
limited by the sett ing in parameter 2202 ACCELERATION RAMP TIME. The
maximum speed is the speed set in parameter 2008 MAXIMUM FREQUENCY /
SPEED LIMIT .
17. To reverse the direction of rotation of the motor, press the key again.
Drive Operating Displays
StoP Drive mains power applied, but no Enable or Run signal applied
H 0.0 Drive running, display shows output
frequency (Hz)
Whilst the drive is running, the
following displays can be selected
by briefly pressing the
button on the drive. Each press of
the button will cycle the display
through to the next selection.
A 0.0 Drive running, display shows motor
current (Amps)
P 0.0 Drive Running, display shows motor
power (kW)
stndbY If the enable/disable switch is opened the drive will decelerate to stop at
which time the display will show
StoP
. If the potentiometer is turned to
zero with the enable/disable closed the display will show
H 0.0
.(0.0Hz) , if
left like this for 60 seconds the drive will go into standby mode, display
shows
stndbY , waiting for a speed reference signal.
ACS260-04.book Page 36 Thursday, December 24, 2020 4:33 PM