Aastra Ascotel IntelliGate 150, Системное руководство

Страница: 152 / 228

Ascotel® IntelliGate® 150/300 as of I7.9
152 Configuration
sy
d-
021
0/1.
7
– I7.
9 – 1
2.
2009
5. 6 Configuration Steps
The configuration steps are based on the information determined during the plan-
ning and, where applicable, the installation.
5. 6. 1 System initialization
If a system is to be upgraded, it must first be in a defined state. This involves setting
or deleting all the parameter values to their initialization value and carrying out a
self-test.
This initialization can be achieved in the following ways:
• With the pilot key on the front panel
• With AIMS
5. 6. 1. 1 Hardware-induced initialization
See "Carrying out a first start", page 186
5. 6. 1. 2 Software-induced initialization
Carry out an initialization in the AIMS Configuration Manager or in the Fault and
Maintenance Manager under "
Online "
→
" Reset PBX ". If the sales channel is also to
be modified, create a new PBX in the AIMS Shell and select a sales channel. Then
under "
Tools "
→
" Set/Change Sales Channel " carry out an initialization using the cor-
responding initialization values.
Note:
To perform a first-start or a sales channel change, either a user account
with the corresponding authorization profile is necessary (see
"User
accounts and authorization profiles", page 137 ) or the local, password-
free access must be open (see "Password-free access", page 143 ).
5. 6. 2 Preparing Configuration with AIMS Offline
The complete configuration of a PBX can be created on the PC without access to
the PBX and stored in the database. When this is done, data can be read in from the
Project Manager and supplemented. The prepared configuration can then be up-
loaded to the PBX.