AAQ AutoLift AL-9500HD, Руководство по установке и инструкции по эксплуатации

Страница: 22 / 42

H
YDRAULIC
H
OSES
25) Attach Power Hose to Cylinder Fitting at the
bottom of the Power Column as shown in
Fig 11
below. Repeat with longer Idler Hose and Idler
Column. If hoist is installed in the “Tall Height”
setting, use Hose Extension and Hose Extension
Fitting between Idler Hose and Cylinder Fitting.
27) Assemble Power Unit, Tee Fitting, and hoses
together as shown in
Fig 13
. Use (4 sets) M8 bolt, nut,
flat washer, and lock washer to attach Power Unit to
column bracket.
Fig 13 – Power unit
Fig 11 – Bottom Hose Connection
26) .
Route hoses through hose guides in Column. 28) Clamp the Idler Hose to the Overhead and
Run Idler hose up through Column Extension, Column Extensions using a (1 set) hose clamp,
over the top of the Overhead, and down through M10 x 25 hex bolt, nut, flat washer, and lock
the opposite Column Extension as shown in washer as shown in
Fig 14
below. For both the
Fig 12
below. Symmetric and Asymmetric configuration, the
hose clamp in the Column Extension should be
on the same side as the hose guides welded on
the Columns.
IMPORTANT:
ENSURE HOSE DOES
NOT CONTACT CYLINDERS WHEN HOIST IS FULLY RAISED
Fig 12 – Hose Routing
POW ER SIDE
Fig 14– Hydraulic Hose Routing
21