AAQ AutoLift AL-9500HD, Руководство по установке и инструкции по эксплуатации

Страница: 19 / 42

4) Assemble Overhead Mounting Bracket to the
Column Extension using (4 sets) M12 x 25 Hex
bolts, flat washers, lock washers, and nuts.
Repeat for opposite bracket and extension.
See
Fig 3
below.
Fig 3 – Column Extension
5) Slide both Carriages into the first lock position
while Columns are horizontal. Ensure both locks
are engaged.
6) Using the Base Width (D) Dimension, chalk
two parallel lines (A & B) on the floor within
3mm tolerance. Chalk a third line (C)
perpendicular to lines A & B to designate fore and
aft location. Erect both Column assemblies. Align
the base plate edges to the chalk lines as seen
in
Fig 4
below. Slots in front and back of base
plate should be in-line with chalk line “C”.
Fig 4 – Layout
A
NCHORING
7) The anchor bolts must be installed at least
200mm from any crack, edge, or expansion joint.
8) Use a concrete hammer drill with a 20mm
carbide bit. Do not use excessively worn bits or
bits which have been incorrectly sharpened.
Never substitute with shorter anchor.
9) Recheck “Base Width” dimension. Drill the anchor
holes (Power Column Only) using the base
plate as a template. Drill through the floor if
possible or to a depth of 125mm minimum.
10) Vacuum dust from the hole for proper holding
power.
11) Shim column to plumb using the shims provided
as shown in
Fig 5
. DO NOT shim more than
12mm at any given point. Use a level to plumb
Columns.
12) Assemble washer and nut to anchor with nut just
below impact section of bolt. Drive anchor into
hole until nut and washer contact base.
Fig 5 – Column Shimming
13) Tighten Power Column anchors and recheck
Column for plumb. Re-shim if necessary. Torque
to 150 foot-pounds to set anchors.
18