AAQ AutoLift AL-162016, Руководство по установке и инструкции по эксплуатации

Страница: 23 / 31

162016
-open the oil make up stop valve “H” on the main machine and close the oil make up
stop valve “G” on the main machine.
-press “up” button SB1, two platforms of the main machine are lifted to the same
height .
End close the oil make up stop valve “H” and open the oil make up stop valve “G”.
EMERGENCY MANUAL OPERATION FOR LOWERING (POWER FAILURE):
When lowering through manual operation, should observe the condition of platform at
any time because there are vehicles on the platform. If there is something abnormal,
screw down oil loop valve immediately.
The process of manual operation:
-firstly lift two safety pawls of platform and use thin iron bar to fill up it.
-switch off the power button (avoid abruptly incoming electricity ). Open the back
cover of control box to find the electromagnetic valve A for lowering.
-loosen manual oil loop stud at the end of lowering electromagnetic valve core, then
the platform begins lowering.
-after the machine has been lowered, screw down manual oil loop stud timely, the
process of manual lowering comes to the end.
(picture 24) (picture25)
The machine should be lower to the lowest position when replace hydraulic oil, then
let the old oil out, and should be filter the hydraulic oil.
-the compressed air used in pneumatic safety devices must be filtered through water
to ensure long time reliable operation of the cylinder and air valve DQ for driving the
safety pawl .