AAQ AutoLift AL-162016, Руководство по установке и инструкции по эксплуатации

Страница: 20 / 31

162016
(picture 19 (picture 20)
Main machine oil make-up adjustment
1-close the oil make up stop valve “H” on the main machine and open the oil make up
stop valve “G” on the main machine.
2-press “lift” button SB1, and thus the left platform ( looking from machine head
direction ) is lifted to about 1000mm.
3-press the “lower” button SB2 to lower the left platform to the lowest position.
4-then lift it up to approximately 1400mm.
5-open the oil make up stop valve “H” on the main machine and close the oil make up
stop valve “G” on the main machine.
6-press “up” button SB1, and the right platform ( looking from machine head
direction ) is lifted to about 1000 mm.
7-press “ lower” button. SB2 to lower the platform to the lowest position.
8-repeat the lifting and lowering process for 6-7times to vent air automatically.
9-then lift the right platform to 1400mm. ( two platforms of the main machine are lifted
to the same height ).
End close the oil make up stop valve “H” and open the oil make up stop valve “G”.
Check oil leakage of the oil line and air tightness of the air loop.
Limit switch of main machine adjustment
- press “SB1” and then lift the platform to 1700mm, adjust limit position of SQ1.
-lower the main machine platform, lift main machine platform to the limit position
several
times to check the efficiency of the limit position of the main machine.
If the ceiling is lower than 4000mm, it should do the limit adjustment after lift
the vehicle.
Anchor bolts installation
-affix the lift to the concrete base with 16 anchor bolts using a percussion drill into
120mm.
Chapter 5 ADJUSTMENT
-At first, no expansion bolts are installed.
-
adjust the parallel of the platform and the distance of
two platform
-lock the machine in one safety teeth
-pad a shim
-adjust the clearance in front and back, and to the left and