AAQ AutoLift AL-162016, Руководство по установке и инструкции по эксплуатации

Страница: 22 / 31

162016
CAUTION
The scissor lift should not be operated when
the platforms are not level.
Before the car is being modified on the scissor
lift, one must check and insure that the lock
units are locking reliably
When locking the lift, one must check and insure
that the lock units are in the same level pitches
the slide resistant triangle woods should be used.
-pay attention to the synchronization of the lifting and lowering. If any
abnormal is found, stop the machine timely, check and remove the trouble.
-when locking the main machine, the two platforms should be kept at the same
height.
-when the equipment is not used for a long time or over night, the machine
should be lowered to the lowest position on ground, and remove vehicle, and
cut off power supply
.
Instructions on electric operation:(see the operation panel)
Scissor Lift For Wheel Aligmment
(picture 23)
Lifting
Press “ lift” button SB1, the machine will be lifted immediately, while motor M starts
operation and the safety pawl is lifted, because the solenoid air valve DQ is
energized and open the air loop ( note: the secondary carriage has no delay of pawl
operation.)
Releasing “ lift” button SB1, the machine will stop immediately, while motor M stops
operation and the safety pawl falls to the safety teeth bar because the solenoid air
valve DQ is energized and air loop is open.
Emergency stop
When the machine have abnormal or car maintenance, push “emergency stop”
button “SB0” and locking, cut off all the operation circuit, other operation can not be
work.
Oil make-up “adjust” operation ( normal service period)
after completion of machine installation and adjustment in the
application process, the right platform is lower than the left one
( looking from machine head ) because of normal looses or leakage of
the hydraulic oil.
When conducting oil make-up operation, the platforms must not be load
.
Chapter 6 OPERATION