A.O. Smith HSE-HNS, Руководство пользователя

Страница: 12 / 24

Installing the remote controller
For convenience of operation, you may install the remote
controller holder/bracket on the wall near the water heater
(a bracket may be used).
Installing the bracket for remote controller:
• The remote controller must be installed at a place
where it does not get in contact with water.
• Drill two holes on the wall by using an electric impact
drill with 6mm bit.
• The holes must be horizontal and space between two
holes is 28mm (Fig. 7).
• Fix the bracket on the wall by expansion tubes and
screws attached.
• Place the remote controller with battery into the
bracket.
Installing the remote controller battery:
• Rotate counter clockwise by a coin and remove the battery cover at the back of the
remote controller.
• Load the CR2025 battery (accessory) into the controller.
Note: “+” up.
• Cover the battery cover and rotate it clockwise by a coin (Fig. 8).
Fig. 7 Bracket for remote
controller
28mm
Fig. 8 Installation diagram of remote controller battery
Battery Size:
CR2025 3V
Rotate after
pressing
Open/close
by a coin
Battery Size:
CR2025 3V
Rotate after
pressing
Open/close
by a coin
Battery Size:
CR2025 3V
CR2025
Battery Size:
CR2025 3V
Rotate after
pressing
Open/close
by a coin
9