Chapter 2. CLI Syntax Reference
97
3ware SAS/SATA RAID Controller CLI Guide, Version 9.5.1
Port Object Commands
Port Object Messages are commands that provide information and perform
actions related to a specific disk, attached to a port (or virtual port), such as
/
c0/p0
. You use port object commands for such tasks as seeing the status,
model, or serial number of the drive.
Note that all refernces to “port” also apply to “VPort” for the commands in
this section.
Syntax
/c
x
/p
x
show
/c
x
/p
x
show attribute [attribute ...] where attributes are:
capacity|firmware|identify (9000 series SX/SE/SA only)|
lspeed (9000 series SX/SE/SA only)|model|
ncq (9000 series SX/SE/SA only)|serial|smart|status|
identify (9000 series SX/SE/SA only)|
driveinfo (9690SA only)
dpmstat type=instr|ra|lct|histdata|ext
(9000 series SX/SE/SA, except for type=ext, which is SE/
SA only)
/c
x
/p
x
show all
/c
x
/p
x
remove [noscan][quiet]
/c
x
/p
x
set identify=on|off (9000 series SX/SE/SA only)
/c
x
/p
x
show
This command shows summary information about the specified disk attached
to port
/c
x
/p
x
.
Example for 9650SE and earlier controllers:
//localhost> /c1/p5 show
Port Status Unit Size Blocks Serial
---------------------------------------------------------
p5 OK u0 149.05 GB 312581808 3JS0L9QW
The above output indicates that port 5 of controller 1 is attached to one disk
with status OK participating in unit 0.
Example for 9690SA controller:
Note that in this case the summary information is in a slightly different format
//localhost> /c3/p1 show
VPort Status Unit Size Type Phy Encl-Slot Model
--------------------------------------------------------------------------
p1 OK u0 149.05 GB SATA 0 - WDC WD1600JS-22NCB1a
