User manual
30
www.3onedata.com
Based on the LACP protocol, the link aggregation can be divided into two modes, static aggregation and
dynamic aggregation.
6.3.7.1 Static configuration
Static aggregation is manually configured by the user, and does not allow the system to automatically add
or remove ports in the sink group. The aggregation group must contain at least one port. When the
aggregation group has only one port, the port can be removed from the aggregation group by deleting the
aggregation group.
In the menu bar, click on the "main menu", "port configuration", "port channel configuration", "Static
configuration", enter the Static configuration interface.
(Figure 6.3.7.1)
Load balance mode of the aggregation group, there are 3 kinds of:
Src Mac: according to the source MAC address of the message to share the load, when the source MAC
address phase at the same time, the message in the same port through, otherwise, the message from
different ports through.
Dst Mac: according to the purpose of the message MAC address for load sharing, when the purpose of
MAC address at the same time, the message in the same port through, otherwise, the message from
different ports through.
Src & Dst Mac: according to the source and destination MAC address for load sharing, when the source
and destination MAC address at the same time, the message in the same port through, otherwise, the
message from different ports through.