19
English 202036A
Check the 3M
TM
Bair Paws
TM
system website to ensure you have the most recent version of this document.
www.bairpaws.com reorder #202036A
Replacing the Temperature Controller and/or Hose
Tools/Equipment Needed
•
Small Phillips screwdriver�
•
Medium Phillips screwdriver�
Method
1� Disconnect the warming unit from the
power source�
2� Remove the two screws that attach
the case bottom (dark purple) to the
warming unit, and slide the case bottom
down the hose�
3� Remove the three screws on the back
of the warming unit that hold the
enclosures together (see Figure 12)�
4� Flip the unit over and remove the cover�
This will expose the control board�
5� Gently pull the end-of-hose coupler out
of the warming unit by a few inches to
expose the controller wire�
6� Disconnect the controller wire from the
control board� You will have to depress
the tab on the controller wire plug
to free it from its port on the control
board�
Figure 12� Removing the enclosure screws�
Back of
warming unit
Case bottom
End-of-hose
coupler
Figure 13� Pull the end-of-hose coupler
out of the warming unit�