11
English 202036A
Check the 3M
TM
Bair Paws
TM
system website to ensure you have the most recent version of this document.
www.bairpaws.com reorder #202036A
Mounting the Warming Unit with a Rail-mount to the Wall
CAUTION:
The rail-to-wall bracket is intended for use only with a Bair Paws 800 series
warming unit�
Note: A minimum of two wall anchors must be used to secure the rail-to-wall bracket to the
wall� Additional wall anchors (up to a total of four) can be used for extra support�
1� Using the wall-screw holes on the rail-to-wall bracket (see Figure 5) as a template,
mark the position for the two wall anchors on the desired wall� The use of a level is
recommended�
2� Install two suitable wall anchors at the marked position� If using the provided self-
drilling wall anchors, use a Phillips
*
screwdriver to screw the anchors into position� If
installing into industrial-grade plasterboard, predrilling may be required�
3� Hold the rail-to-wall bracket in position against the wall�
4� Screw the two provided screws through the bracket holes and into the wall anchors�
5� If the warming unit is not already connected to the rail-mount, slide the clip on the
back of the warming unit into the groove of the rail-mount� The assembly will click
when the clip is fully seated in the rail-mount�
6� Hook the warming unit with the attached rail-mount to the rail-to-wall bracket as
depicted in Figure 5�
7� Lift the warming unit straight up to remove it from the rail-to-wall bracket�
Figure 5� Placing the warming unit with a rail-mount onto the rail-to-wall bracket�
*Phillips is a trademark of Phillips Screw Company
Rail-to-wall
bracket
Rail-mount