3D Systems, Inc.
2
p/n 76-D022 Rev. A
2
UNCRATING THE MACHINE
INSPECT EXTERIOR OF CRATE
Visually inspect the exterior of the crate for any damage that may
have occurred during shipping. Notify shipping carrier immediately
to file a claim if any damage is evident at this point. DO NOT
proceed with the uncrating until you have discussed the damage
with 3D Systems.
NOTE: Uncrating the ProX® SLS 6100 will require at
least two people to safely remove the each panel .
1 . Located on the side of the crate is the “clip removeal tool” . It
is secured under a clip . To release the tool, grab the handle
and pull it towards you to pop out the first clip.
NOTE: To keep clips from popping off too quickly
you may want to hold your hand over the top of the
clip .
2 . Using at least a 5 foot sized ladder, remove the (12) clips
from the side of the crate as shown . Remove and place
panel to the side .
3 . Remove the remaining (8) clips that secure the top panel .
Carefully slide/guide the top crate panel towards the other
side of the crate until it reaches a tipping point . Tip and
lower the panel to the ground . Set panel to the side .
4 . Remove the (6) clips (circled in red) from one side of the
crate panel . Remove panel and place to the side . Repeat
step on opposite side .
5 . Remove the final side panel by removing the bottom (2) clips
(circled in blue) . Place panel to the side .