3Com EtherLink 3C985B-SX, Руководство пользователя

Страница: 56 / 113

Load Balancing/RSL Commands 55
send tmo
This command sets the timeout value, in seconds, that
Load Balancing/RSL software waits before retransmitting a
probe packet when a send request to the link support layer
(LSL) is not acknowledged.
set probe interval
This command sets the probe packet interval.
unbind
This command deletes a Load Balancing/RSL group (the
LAN driver for the group cannot be loaded).
Syntax el980lb send tmo pri_slot value_in_seconds
where:
pri_slot is the PCI slot number of the primary NIC.
value_in_seconds is any positive integer.
Example el980lb send tmo 1001 20
Default 10
Messages A separate message is displayed for each loaded
frame type.
Syntax el980lb set probe interval in_ticks
where in_ticks is the time in ticks (18 ticks = 1 second).
Example el980lb set probe interval 60
Default 18
If the delay is longer than 1 second, NIC or link failures
are not recognized as quickly.
Messages If no argument is specified or the specified argument is
invalid, the current value is displayed. Otherwise, the
new value is displayed.
Syntax el980lb unbind pri_slot
where:
pri_slot is the PCI slot number of the primary NIC.
Example el980lb unbind 10001
Default None
Messages If successful, Load Balancing/RSL software displays this
message for all frame types that the NIC supports:
Cleaning up resources for group
associated with Primary Slot # xxxx.
Book Page 55 Monday, June 7, 1999 2:14 PM