ZyXEL Communications ZyXEL ZyWALL P1, User Manual

Page: 146 / 369

ZyWALL P1 User’s Guide
Chapter 9 VPN Screens 145
Note: When there is outbound traffic but no inbound traffic, the SA times out
automatically after two minutes. A tunnel with no outbound or inbound traffic is
"idle" and does not timeout until the SA lifetime period expires. See
Section
9.4.2 on page 131 on keep alive to have the ZyWALL renegotiate an IPSec SA
when the SA lifetime expires, even if there is no traffic.
Figure 57 VPN: SA Monitor
The following table describes the labels in this screen.
9.10 Configuring Global Setting
To change your ZyWALL’s global settings, click VPN , then the Global Setting tab. The
screen appears as shown.
Table 46 SA Monitor
LABEL DESCRIPTION
# This is the security association index number.
Name This field displays the identification name for this VPN policy.
Local Network This field displays the IP address of the computer using the VPN IPSec feature of
your ZyWALL.
Remote Network This field displays IP address (in a range) of computers on the remote network
behind the remote IPSec router.
Encapsulation This field displays Tunnel or Transport mode.
IPSec Algorithm This field displays the security protocols used for an SA.
Both AH and ESP increase ZyWALL processing requirements and
communications latency (delay).
Refresh Click Refresh to display the current active VPN connection(s).
Disconnect Select a security association index number that you want to disconnect and then
click Disconnect .