ZyXEL Communications ZyXEL ZyWALL P1, User Manual

Page: 81 / 369

ZyWALL P1 User’s Guide
80 Chapter 5 WAN Screens
Figure 25 WAN: Route
The following table describes the labels in this screen.
5.3 Configuring WAN Setup
To change your ZyWALL's WAN ISP, IP and MAC settings, click WAN , then the WAN tab.
The screen differs by the encapsulation.
5.3.1 Ethernet Encapsulation
The screen shown next is for Ethernet encapsulation.
Table 21 WAN: Route
LABEL DESCRIPTION
Route Priority
WAN The default WAN connection is "1” as your broadband connection via the WAN port
should always be your preferred method of accessing the WAN.
Windows
Networking
(NetBIOS over
TCP/IP):
NetBIOS (Network Basic Input/Output System) are TCP or UDP packets that
enable a computer to connect to and communicate with a LAN. For some dial-up
services such as PPPoE or PPTP, NetBIOS packets cause unwanted calls.
Allow between
WAN and LAN
Select this check box to forward NetBIOS packets from the LAN to the WAN and
from the WAN to the LAN. If your firewall is enabled with the default policy set to
block WAN to LAN traffic, you also need to enable the default WAN to LAN firewall
rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the WAN
and from the WAN to the LAN.
Allow Trigger Dial Select this option to allow NetBIOS packets to initiate calls.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to begin configuring this screen afresh.