ZyXEL Communications ZYAIR, User Manual

Page: 227 / 402

ZyAIR Wireless Gateway Series User’s Guide
19-8 LAN Setup
Table 19-4 Menu 3.5 Wireless LAN Setup
FIELD DESCRIPTION EXMAPLE
WEP Select Disable to allow wireless stations to communicate with the access
points without any data encryption.
Select
64-bit WEP or 128-bit WEP to enable data encryption.
Disable
Default Key Enter the key number (1 to 4) in this field. Only one key can be enabled at
any one time. This key must be the same on the ZyAIR and the wireless
stations to communicate.
1
Key 1 to
Key 4 The WEP keys are used to encrypt data. Both the ZyAIR and the wireless
stations must use the same WEP key for data transmission.
If you chose 64-bit WEP in the WEP Encryption field, then enter any 5
ASCII characters or 10 hexadecimal characters ("0-9", "A-F").
If you chose
128-bit WEP in the WEP Encryption field, then enter 13
ASCII characters or 26 hexadecimal characters ("0-9", "A-F").
Enter “0x” before the key to denote a hexadecimal
key. Don’t enter “0x” before the key to denote a ASCII
key.
0x12345abcde
Authen.
Method Press [SPACE BAR] to select Auto , Open System Only or Shared Key
Only and press [ENTER].
This field is N/A if WEP is not activated.
If WEP encryption is activated, the default setting is Auto .
Auto
Block Intra-
BSS Traffic Press [SPACE BAR] to select Yes or No and press [ENTER]. No
Number of
Associated
Stations Enter the maximum number of wireless stations that may connect to the
ZyAIR. The number should be from 1 to 32.
Breathing
LED
Press [SPACE BAR] to select Yes or No and press [ENTER]. Yes
Output
Power Press [SPACE BAR] to select 11dBm , 13dBm , 15dBm or 17dBm and
press [ENTER].
17dBm