ZyXEL Communications XS-3900-48F, User Manual

Page: 282 / 332

Chapter 36 Access Control
XS3900-48F User’s Guide
282
36.3.4 Configuring SNMP
From the Access Control screen, display the SNMP screen. You can click Access Control to go
back to the Access Control screen.
Figure 168
Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 135
Management > Access Control > SNMP
LABEL DESCRIPTION
General Setting Use this section to specify the SNMP version and community (password) values.
Version Select the SNMP version for the Switch. The SNMP version on the Switch must match
the version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3
(v3) or both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP version 1.
Get Community Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or
lower.
Set Community Enter the Set Community string, which is the password for the incoming Set-
requests from the management station.
The Set Community string is only used by SNMP managers using SNMP version 2c or
lower.
Trap Community Enter the Trap Community string, which is the password sent with each trap to the
SNMP manager.
The Trap Community string is only used by SNMP managers using SNMP version 2c or
lower.
Trap Destination Use this section to configure where to send SNMP traps from the Switch.
Version Specify the version of the SNMP trap messages.
IP Enter the IP addresses of up to four managers to send your SNMP traps to.
Port Enter the port number upon which the manager listens for SNMP traps.