![background image](http://html.mh-extra.com/html/zyxel-communications/wap6906/wap6906_user-manual_945573012.webp)
Chapter 1 Introduction
WAP6906 User’s Guide
12
The following table describes the LED behavior.
The timeline below helps you understand more about the WAP6906 LED behavior.
1.5 Rear Panel
The following figure is the rear panel of the WAP6906.
Table 1 Front Panel LEDs
LED
COLOR
STATUS
DESCRIPTION
Top LED
White
Blinking
The WAP6906 is upgrading its firmware, rebooting or resetting.
Blue
On
The WAP6906 is receiving power and functioning properly, but the
wireless interface of the WAP6906 is not up or it has been up for more
than 5 minutes.
Blinking
The WAP6906 is turning on.
Purple
On
The LED is on for 1 minute indicating the WPS process was successful.
Blinking
The WAP6906 is negotiating a WPS connection with a wireless client.
Green
On
The LED is on for 5 minutes indicating the wireless router or AP and
WAP6906 are connected, and the received signal strength is good.
Amber
On
The LED is on for 5 minutes indicating the wireless router or AP and
WAP6906 are connected, and the received signal strength is too
strong. This may cause interference with the wireless router or AP’s
signal. Move the WAP6906 away from the wireless router or AP for a
larger range.
Blinking
The LED is blinking for 1 minute indicating the WPS process failed.
Red
On
The LED is on for 5 minutes indicating the wireless router or AP and
WAP6906 are connected, and the received signal strength is poor.
Move the WAP6906 closer to your wireless router or AP.
Blinking
The WAP6906 lost its wireless connection to the AP. Find a new location
for the WAP6906 or press the WPS button to restart the WPS process.
Off
The WAP6906 is not receiving power.
LAN Port LED Green
On
The WAP6906 has a successful 10/100/1000 Mbps Ethernet connection.
Blinking
The WAP6906 is sending or receiving packets to/from an Ethernet
network on this port.
Off
There is no connection on this port.