Chapter 8 Wireless LAN
WAP6906 User’s Guide
51
8.5 Advanced Wireless Network Screen
Use this screen to select the advanced wireless settings for the WAP6906.
Click
Networking > Wireless Network 2.4G >
Advanced
. The screen appears as shown.
Figure 25
Networking > Wireless Network 2.4G > Advanced
The following table describes the labels in this screen.
8.6 WPS Screen
Use this screen to enable/disable WPS, view or generate a new PIN number and check current WPS
status. To open this screen, click
Networking > Wireless Network 5G/2.4G > WPS
.
Table 15 Networking > Wireless Network 2.4G > Advanced
LABEL
DESCRIPTION
Wireless Band
Select the wireless standard you want to use for your wireless network.
Channel
Bandwidth
Select the channel bandwidth you want to use for your wireless network.
Select whether the WAP6906 uses a wireless channel width of
20MHz
or
40MHz
. A standard
20MHz channel offers transfer speeds of up to 150Mbps whereas a 40MHz channel uses two
standard channels and offers speeds of up to 300 Mbps.
Beacon Interval
This is the time lag between each of the beacons sent by the wireless network.
DTIM Period
The Delivery Traffic Indication Map (DTIM) period, is the moment the WAP6906 will broadcast
any buffered broadcast frames, after the WAP6906 broadcasts the beacon. Enter 1, and the
WAP6906 will transmit broadcast frames after every beacon, enter 2 and the WAP6906 will
transmit every other beacon.
Short Guard
Interval
Enable the
Short Guard Interval
to ensure the WAP6906 transmissions do not interfere with
each other.
Apply
Click
Apply
to save your changes to the WAP6906.
Cancel
Click
Cancel
to reload the previous configuration for this screen.
