ZyXEL Communications Prestige 28641, User Manual

Page: 69 / 159

Remote Node Configuration 55
if available. Once connected, the Prestige will use the BACP
(Bandwidth Allocation Control Protocol) to establish the second B-
channel if Multilink PPP is enabled, and the Remote Node supports
MP and BACP.
Some areas require dialing # before the phone number for local
calls. A # symbol may be included at the beginning of the Primary
Phone number or Secondary Phone number.
12. Route - This fields determines the protocols that the Prestige will
route. The choices for this field are determined by the features
enabled on your Prestige.
13. Bridge - Bridging is used for protocols that are not supported or
not turned on in the previous Route field by the Prestige, e.g., SNA.
When bridging is enabled, the Prestige will forward any packet that
it does not recognize to this Remote Node; otherwise, the
unrecognized packets are discarded. The disadvantage of bridging
is that it usually generates large amounts of traffic. Press the space
bar to select either Yes or No.
14. Edit PPP Options - To edit the PPP options for this Remote
Node, move the cursor to this field, use the space bar to select Yes
and press ENTER . This will bring you to Menu 11.2 - Remote
Node PPP Options For more information on configuring PPP
options, see the section Editing PPP Options.
15. IP Addr - This is a required field if Route is set to IP. Enter the IP
address of this Remote Node.
16. Edit IP/IPX/Bridge Options - To edit the parameters of the
protocols, go to this field, select Yes and press ENTER. This will
bring you to Menu 11.3 - Remote Node Network Layer Options.
For more information on filling out this screen, refer to the chapter
pertaining to your specific protocol.